JB4tech.com - International Turbo Tuning Discussion

JB4tech.com - International Turbo Tuning Discussion (https://www.jb4tech.com/forums/index.php)
-   N55 (https://www.jb4tech.com/forums/forumdisplay.php?f=16)
-   -   Quick disconnect fittings for Can wires? (https://www.jb4tech.com/forums/showthread.php?t=50431)

bullcitybmmer 11-14-2017 08:22 AM

Quick disconnect fittings for Can wires?
 
Hi everyone, I did a search for this topic, but couldn't find anything. Due to various reasons, I've had to remove and re-install my JB4 a few times over the past few weeks, and I'm getting a little bit tired of unwrapping and rewrapping that sticky tape around the wire bundle. I was curious to see if anyone has tried placing a quick disconnect fitting in the JB4 can wires between the module and the big wiring bundle, so it's just plug and play. It seems like a simple electrical connection, but I know it gets finnicky already if the connection isn't solid, so I wasn't sure if this would degrade the signal enough to cause issues.

To be clear, I'm talking about a connector along the lines of this:
https://ae01.alicdn.com/kf/HTB1b.RTS...pg_220x220.jpg

Thoughts? I figure if I can't find a lot of info where anyone has done this it might not be the best idea, but I wanted to check anyway.

Terry @ BMS 11-14-2017 08:42 AM

Anything should be fine for that.

bullcitybmmer 11-14-2017 08:58 AM

Quote:

Originally Posted by Terry @ BMS (Post )
Anything should be fine for that.

Cool, thanks Terry. I'll give it a shot and see how it goes.

protecon 11-14-2017 03:39 PM

I did this already on my S63 - just pull back the tape far enough and you should see where the CANBUS wires join together. I just added a spade plug to each join.

http://i.imgur.com/JejAZcZ.jpg


All times are GMT -7. The time now is 05:56 PM.


Copyright 2007 - 2022, JB4tech.com