JB4tech.com - International Turbo Tuning Discussion
Register Search Today's Posts Mark Forums Read
Go Back   JB4tech.com - International Turbo Tuning Discussion > Search Forums
Reload this Page Search Results
Page 1 of 4 1 23 Last »
Showing results 1 to 25 of 79 Search: Posts Made By: lukas
Forum: N54 05-10-2018, 07:50 AM
Replies: 8
Views: 1,807
Posted By lukas
you don't need to break in new turbochargers

you don't need to break in new turbochargers
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 05-08-2018, 02:00 PM
Replies: 16
Views: 3,211
Posted By lukas
You can look up "VS MAP sensor to BOV Line...

You can look up "VS MAP sensor to BOV Line Adapter" from vader solution it's $60 tho
Forum: N54 04-26-2018, 03:21 PM
Replies: 109
Views: 24,648
Posted By lukas
So you can't just take some high-temp tape and...

So you can't just take some high-temp tape and wrap around your 1-3/4" OD compressor inlet until you get that 2" OD?
Forum: N54 04-25-2018, 01:10 PM
Replies: 16
Views: 4,371
Posted By lukas
1. 2C7F - Lambda probe behind catalytic converter...

1. 2C7F - Lambda probe behind catalytic converter 2, trimm control
2. PCV valve is just a fancy name for a check valve that allows air to flow through it in only one direction - out of engine into...
Forum: JB4 Mobile 04-19-2018, 10:10 AM
Replies: 4,856
Views: 2,134,005
Posted By lukas
Have you guys ever thought off making some type...

Have you guys ever thought off making some type of constant logging function where if enabled JB4 would constantly overlappingly save all parameters for the last lets say 60 seconds or whatever...
Forum: N54 04-12-2018, 10:16 AM
Replies: 35
Views: 10,109
Posted By lukas
I'm sure he started it just for fun because you...

I'm sure he started it just for fun because you need to be blind not to see this coming:)
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 04-12-2018, 08:11 AM
Replies: 7
Views: 1,928
Posted By lukas
To reach that target you need to press the...

To reach that target you need to press the accelerator pedal to the floor and keep it there. Try that
Forum: N54 04-10-2018, 03:28 PM
Replies: 16
Views: 4,371
Posted By lukas
swapped post *** o2 sensors and leaking...

swapped post *** o2 sensors and leaking turbochargers is what I think
Forum: N54 03-28-2018, 12:44 PM
Replies: 109
Views: 24,648
Posted By lukas
So have you seen the inlet and confirmed that it...

So have you seen the inlet and confirmed that it failed because of poor quality and not because of bad install or is it just a gossip again?
I could apply this to all of your products but it...
Forum: N54 03-14-2018, 09:53 AM
Replies: 109
Views: 24,648
Posted By lukas
LOL this is great! Back to the topic I think it...

LOL this is great!
Back to the topic I think it would be great offering considering what we have right now:
VTT $349.00
RB $325.00
VRSF $224.99
MMP $200.00
China sais it's "5 ply silicone...
Forum: N54 03-13-2018, 08:22 AM
Replies: 6
Views: 2,123
Posted By lukas
5" is 5" wide 7" is 7" wide. As far as I know...

5" is 5" wide 7" is 7" wide. As far as I know they both are trash if you don't got with high density fin pack
Forum: N54 03-12-2018, 02:23 PM
Replies: 18
Views: 7,132
Posted By lukas
You should remove the intake manifold, use number...

You should remove the intake manifold, use number 7 drill bit to drill a hole, use 1/4-20 tap to thread it, install brass fitting in that hole, clean debris from the manifold and put it back...
Forum: N54 03-08-2018, 11:30 AM
Replies: 13
Views: 3,484
Posted By lukas
listen to rocky335i

listen to rocky335i
Forum: N54 03-05-2018, 03:47 PM
Replies: 5
Views: 1,805
Posted By lukas
Based on BMW recommendations 10w30 oil is too...

Based on BMW recommendations 10w30 oil is too thick for this engine when it's cold. I would do a compression test first
Forum: N54 03-05-2018, 11:07 AM
Replies: 5
Views: 1,805
Posted By lukas
Where are you located? Was the car kept inside or...

Where are you located? Was the car kept inside or outside during winter? Do you have *** less d p's? Does it smoke when the engine is warmed up and if it does is it still smoking mostly from the left...
Forum: JB4 Mobile 02-09-2018, 10:56 AM
Replies: 4,856
Views: 2,134,005
Posted By lukas
Are there any new gauge themes coming up? Right...

Are there any new gauge themes coming up? Right now we have two options, original looks like from Saturn V and the other would suite GT-R's and Supras but I wish for something matching our stock...
Forum: N54 02-05-2018, 10:00 AM
Replies: 15
Views: 3,140
Posted By lukas
damn thing cost more than the engine

damn thing cost more than the engine
Forum: N54 01-23-2018, 09:17 AM
Replies: 5
Views: 3,124
Posted By lukas
The light one is new model. In order to save some...

The light one is new model. In order to save some $ on material instead of casting solid cams they started to hydroform steel tubing into cams. I heard you can mix and match them
Forum: N54 12-12-2017, 03:53 PM
Replies: 5
Views: 2,491
Posted By lukas
who sleeves your block?

who sleeves your block?
Forum: N54 11-10-2017, 03:35 PM
Replies: 3
Views: 1,987
Posted By lukas
I don't think that matters unless you want to...

I don't think that matters unless you want to relocate/install something else and it can get in your way
Forum: N54 11-09-2017, 05:44 PM
Replies: 31
Views: 9,167
Posted By lukas
In Europe you stay on the right lane all the time...

In Europe you stay on the right lane all the time (highways and city streets) unless you need to pass someone or turn left and if cops see you coasting on the left line you can get a ticket. Notice...
Forum: N54 11-02-2017, 01:07 PM
Replies: 39
Views: 11,343
Posted By lukas
My bad I missed to see that you have 535i. You...

My bad I missed to see that you have 535i. You should change trans pan and only gasket for engine oil pan. I don't think you need to drop subframe for your trans pan but for 335i you need to drop...
Forum: N54 11-02-2017, 09:31 AM
Replies: 39
Views: 11,343
Posted By lukas
if you go for the oil pan you should consider...

if you go for the oil pan you should consider engine mounts as well. 335is mounts would be an upgrade
Forum: N54 11-01-2017, 08:20 AM
Replies: 0
Views: 1,385
Posted By lukas
Oil Cooler Gasket Only?

Hi guys,
I have replaced my OFHG and OCG around 20k miles ago and now I see a sump of oil next to my oil filter cap and I know it's not from the cap. Has anyone replaced only OCG leaving OFH in...
Forum: N54 10-26-2017, 08:07 AM
Replies: 24
Views: 7,942
Posted By lukas
it would be helpful if you guys provide any...

it would be helpful if you guys provide any reason why you think this particular turbocharger is better
Search took 0.01 seconds.
Page 1 of 4 1 23 Last »

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright © 2007 - 2022, JB4tech.com

Contact Us - JB4tech.com - Archive - Top