JB4tech.com - International Turbo Tuning Discussion
Go Back   JB4tech.com - International Turbo Tuning Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 20 of 20 Search: Posts Made By: killdro
Forum: Support & Log Review 12-01-2020, 03:42 PM
Replies: 0
Views: 782
Posted By killdro
Log review. Low boost.

Just switched my car back to pump from e60. I'm about to move to an area that doesn't have e85. I've been having very low boost ( like 4-6 psi as opposed to 14). I'm not sure if I should be chasing...
Forum: N54 05-19-2020, 05:30 PM
Replies: 27
Views: 4,259
Posted By killdro
Been having this same issue with my trans. Slips...

Been having this same issue with my trans. Slips in 5th and 6th gear. I have replaced the solenoids with no luck. Was planning on pulling the transmission in the future to replace the clutch packs....
Forum: N54 03-03-2019, 07:39 PM
Replies: 2
Views: 1,192
Posted By killdro
Jb4 app. And yes I have been driving around all...

Jb4 app. And yes I have been driving around all day. Still shows 0 for e85.
Forum: N54 03-03-2019, 02:11 PM
Replies: 2
Views: 1,192
Posted By killdro
Fuel it ethanol analyzer not showing up in jb4

Installed the Platinum fuel line kit from fuel it which includes the ethanol analyzer. I also have port injection set up so I wired it into pin 2 instead of pin 15 for my n54. The jb4 shows e85 as 0...
Forum: N55 01-03-2019, 08:47 PM
Replies: 0
Views: 1,152
Posted By killdro
INPA Files

Anyone know where I can find update DATEN files so that I can use my inpa with my N55?
Forum: Support & Log Review 01-03-2019, 05:46 PM
Replies: 5
Views: 1,706
Posted By killdro
I figured it would be something like that. Just...

I figured it would be something like that. Just trying to get everyone else's ideas on what it could be in case I glance over something.
Forum: Support & Log Review 01-03-2019, 05:44 PM
Replies: 5
Views: 1,706
Posted By killdro
Just checked the VANOS solenoid bolts and they...

Just checked the VANOS solenoid bolts and they are still firmly intact.
Forum: Support & Log Review 01-03-2019, 05:29 PM
Replies: 5
Views: 1,706
Posted By killdro
I looked up some about it and have to figure out...

I looked up some about it and have to figure out where everything is. I am more used to my n54. I did read up that there were recalls to it but I figured since it was a 2013 the recall had already...
Forum: Support & Log Review 01-03-2019, 05:21 PM
Replies: 5
Views: 1,706
Posted By killdro
Code 2DCE

I have a 2013 135i fbo. It threw the 2DCE code and when i looked at my boost gauge it was at -20 and never got above 1. Opened up the valve cover and replaced the eccentric shaft servo motor. Started...
Forum: N54 10-30-2018, 11:43 AM
Replies: 0
Views: 1,251
Posted By killdro
Front brake rebuild

My front driver's side caliper was wearing the inside brake pad waaayyy more then the outside pad so I decided to take it out and rebuild it. I got the piston, boots, and seal ring on the inside of...
Forum: N55 04-02-2018, 02:44 PM
Replies: 1
Views: 1,367
Posted By killdro
I use usb C and it works just fine. Try plugging...

I use usb C and it works just fine. Try plugging the OTG cable in first and then plugging the jb4 cable into it.
Forum: N54 12-14-2017, 01:52 PM
Replies: 13
Views: 4,228
Posted By killdro
I have this same issue and I have narrowed it...

I have this same issue and I have narrowed it down to the injector. To the point where I pulled the injector and noticed that the seal was ****ed. I cleaned off around the seal and it went away until...
Forum: Market Place - For Sale / Trade / Wanted 12-06-2017, 03:53 AM
Replies: 2
Views: 1,810
Posted By killdro
Pictures?

Pictures?
Forum: N54 11-02-2017, 02:48 PM
Replies: 80
Views: 11,982
Posted By killdro
I'm in.

I'm in.
Forum: N54 10-13-2017, 04:32 PM
Replies: 20
Views: 4,445
Posted By killdro
Why not just flash the car with a backend flash....

Why not just flash the car with a backend flash. Not much happens because the car is not technically running.
Forum: N54 09-16-2017, 12:24 PM
Replies: 1,107
Views: 495,750
Posted By killdro
I use map 5

I use map 5
Forum: N54 09-15-2017, 04:00 PM
Replies: 1,107
Views: 495,750
Posted By killdro
Ant lag installed and a lot of fun to use but I...

Ant lag installed and a lot of fun to use but I only ever get up to 10 psi. What in the BEF file to I have to adjust to bump it up to 15 psi?
Forum: Market Place - For Sale / Trade / Wanted 08-14-2017, 07:22 AM
Replies: 11
Views: 3,906
Posted By killdro
PM'd

PM'd
Forum: Market Place - For Sale / Trade / Wanted 08-11-2017, 11:49 AM
Replies: 3
Views: 1,753
Posted By killdro
Mileage?

Mileage?
Forum: Market Place - For Sale / Trade / Wanted 05-05-2017, 09:30 PM
Replies: 28
Views: 8,652
Posted By killdro
Do you have pictures of the rear diffuser....

Do you have pictures of the rear diffuser. Curious to see if it will fit my 08 135i.
Search took 0.00 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2022, JB4tech.com