JB4tech.com - International Turbo Tuning Discussion
Register Search Today's Posts Mark Forums Read
Go Back   JB4tech.com - International Turbo Tuning Discussion > Search Forums
Reload this Page Search Results
Page 1 of 2 1 2
Showing results 1 to 25 of 32 Search: Posts Made By: defineste90
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 08-09-2018, 05:53 PM
Replies: 5
Views: 1,481
Posted By defineste90
Payam changed wastegate springs and made huge...

Payam changed wastegate springs and made huge difference running 13 psi on wastegate pressure but on higher boost levels its not making the boost it should sounded like the bov fluttering while wot...
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 08-09-2018, 05:24 AM
Replies: 5
Views: 1,481
Posted By defineste90
Yea i figured id may run into this problem been...

Yea i figured id may run into this problem been trying to find someone that can do it around me
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 08-07-2018, 04:23 AM
Replies: 5
Views: 1,481
Posted By defineste90
going to try to change waste gate spring tomorrow...

going to try to change waste gate spring tomorrow if i go WOT in lower RPMS it will miss not sure if that is related to the waste gate spring, also everytime i start the car it throws a codes and...
Forum: N54 08-03-2018, 05:02 PM
Replies: 3,137
Views: 1,347,388
Posted By defineste90
Thanks what do you suggest I have tial wastegates

Thanks what do you suggest I have tial wastegates
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 08-03-2018, 03:13 PM
Replies: 5
Views: 1,481
Posted By defineste90
log look over

just got the car running and its running good but still has hiccups especially right befopre boost kicks in running a PT6870 can you guys jhelp me out i have a event i want to run the 11th MPACT roll...
Forum: N54 08-03-2018, 02:53 PM
Replies: 3,137
Views: 1,347,388
Posted By defineste90
can you take a look at these logs

can you take a look at these logs
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 07-13-2018, 09:26 AM
Replies: 4
Views: 1,656
Posted By defineste90
Upgraded JB4 Chip

how can i tell if the chip on the board is the old one also which chip is it? the two look the same and have similar numbers?
Forum: N54 06-27-2018, 09:12 AM
Replies: 39
Views: 7,728
Posted By defineste90
what should voltage be to the tmap sensor i was...

what should voltage be to the tmap sensor i was showing 1.97
Forum: N54 06-26-2018, 06:19 PM
Replies: 39
Views: 7,728
Posted By defineste90
Would 2ABC cause 3100? Nvm everything came back

Would 2ABC cause 3100? Nvm everything came back
Forum: N54 06-26-2018, 11:07 AM
Replies: 39
Views: 7,728
Posted By defineste90
thanks terry! where would that setting be i...

thanks terry! where would that setting be i switched from the 3.5 bar sensor to this 4 bar sensor. i got it back when u first released them(2yrs ago maybe) havent pulled it out yet to check if its a...
Forum: N54 06-26-2018, 05:11 AM
Replies: 39
Views: 7,728
Posted By defineste90
these are the codes i have coming up doing some...

these are the codes i have coming up doing some research last night i have some things to check on also but here they are
2ABC - BOOST-PRESSURE SENSOR, ELECTRIC
2C9E - OXYGEN SENSOR HEATER AFTER...
Forum: N54 06-25-2018, 05:44 AM
Replies: 39
Views: 7,728
Posted By defineste90
would the counterfeit one cause a code to be...

would the counterfeit one cause a code to be thrown for this sensor?
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 06-22-2018, 09:02 AM
Replies: 10
Views: 1,886
Posted By defineste90
had this issue once ended up being the JB4 i...

had this issue once ended up being the JB4 i removed it and the car ran fine Burger replaced it for me and everything was fine after that
Forum: N54 06-11-2018, 12:20 PM
Replies: 3,137
Views: 1,347,388
Posted By defineste90
these are the codes in the DME 002D33 ABSOLUTE...

these are the codes in the DME
002D33 ABSOLUTE PRESSURE SENSOR
003100 BOOST PRESSURE CONTROL

im going up with my trailer tomorrow to get the car and look it over myself if anyone has ideas with...
Forum: N54 06-08-2018, 02:53 PM
Replies: 3,137
Views: 1,347,388
Posted By defineste90
Hey guys having a problem with my freshly built...

Hey guys having a problem with my freshly built motor and single turbo. I have a lower compression motor 9.2:1 car is throwing a boost plausibilty fault and wont make any boost even on wastegate...
Forum: N54 10-12-2017, 11:52 AM
Replies: 22
Views: 9,151
Posted By defineste90
from what i see most guys running single turbos...

from what i see most guys running single turbos are still running stock motors, building might give you a longer life cycle but you never know
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 09-20-2017, 08:49 AM
Replies: 12
Views: 3,171
Posted By defineste90
DID U CODE THE 3.5 SENSOR TO THE CAR?

DID U CODE THE 3.5 SENSOR TO THE CAR?
Forum: N54 09-11-2017, 06:31 AM
Replies: 3
Views: 2,084
Posted By defineste90
log it and post it up

log it and post it up
Forum: N54 08-31-2017, 05:06 AM
Replies: 5
Views: 2,169
Posted By defineste90
Any codes coming up? i would replace it they have...

Any codes coming up? i would replace it they have come down a lot on in price
Forum: N54 08-01-2017, 06:09 AM
Replies: 8
Views: 2,721
Posted By defineste90
id assume he means modified internals since its...

id assume he means modified internals since its now hard to find a N54 that hasn't had at least a tuner on it haha.

Mine is fully built.... but not done yet
Forum: N54 07-28-2017, 04:39 AM
Replies: 15
Views: 3,052
Posted By defineste90
i heard rumors of JTSWOLE runs some NOS on his ST...

i heard rumors of JTSWOLE runs some NOS on his ST but i cant confirm
Forum: N54 07-26-2017, 10:41 AM
Replies: 24
Views: 6,759
Posted By defineste90
N54 HAS NO SOUL? not sure about that unless you...

N54 HAS NO SOUL? not sure about that unless you sell your soul for a large single turbo so you can spank every M car out
Forum: Market Place - For Sale / Trade / Wanted 07-11-2017, 11:55 AM
Replies: 7
Views: 3,268
Posted By defineste90
PMed about roll cage

PMed about roll cage
Forum: DIY Modification 06-15-2017, 12:27 PM
Replies: 54
Views: 23,580
Posted By defineste90
They dont list it on the website for some reason...

They dont list it on the website for some reason just hit up in a email-----> steve@fuel-it.com
Forum: DIY Modification 06-15-2017, 11:41 AM
Replies: 54
Views: 23,580
Posted By defineste90
I dealt with Steve from fuel it directly i was...

I dealt with Steve from fuel it directly i was very impressed with the quality of everything down to every single part being labeled.
Search took 0.01 seconds.
Page 1 of 2 1 2

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright © 2007 - 2022, JB4tech.com

Contact Us - JB4tech.com - Archive - Top