JB4tech.com - International Turbo Tuning Discussion
Prev Previous Post   Next Post Next
bullcitybmmer bullcitybmmer is offline
Junior Member
Posts: 34
Join Date: Sep 2017
Car: 2013 335i e92 M Sport
Default Quick disconnect fittings for Can wires? - 11-14-2017, 08:22 AM

Hi everyone, I did a search for this topic, but couldn't find anything. Due to various reasons, I've had to remove and re-install my JB4 a few times over the past few weeks, and I'm getting a little bit tired of unwrapping and rewrapping that sticky tape around the wire bundle. I was curious to see if anyone has tried placing a quick disconnect fitting in the JB4 can wires between the module and the big wiring bundle, so it's just plug and play. It seems like a simple electrical connection, but I know it gets finnicky already if the connection isn't solid, so I wasn't sure if this would degrade the signal enough to cause issues.

To be clear, I'm talking about a connector along the lines of this:

Thoughts? I figure if I can't find a lot of info where anyone has done this it might not be the best idea, but I wanted to check anyway.
Reply With Quote

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2022, JB4tech.com